この記事はXPROG-M V5.55プログラマを使用して、BMW E46 M35080 EEPROMを読むこと及びM35080を読み込むときに、「FF FF」エラーを解決する方法についての記事です。
すべては「FF」のエラーから始まりました!
クラスタを分解して、M35080のピンに直接ハンダ付け、それでも同じ結果を得た、FF FFの読み取り
考えられる原因:
XPROG-mはM35080のために使用M3508016ピンアダプタプログラミングボードが正常に動作していません。
”99% sure the FF reads are due to the adapter board” (by a xprog-m user)
実行する方法:
replaced the 8 wire harness with a new one and the soldering is as it should be to remove the 8 wires from the board, connect brass pins and connect the 8 wires to the corresponding slots on the 16 pin connector thus avoiding the use of the board
XPROG M35080アダプタプログラミングボードの一部:
soldered the wires directly to the corresponding pins off of the connector that connects to the xprog and thus bypassed the M35080 xprog green board:
the M35080 pin order and the Xprog-m 16 pin connector pin labels so that the correct 7 pins can be sequenced between the M35080 eeprom and the Xprog-m special programming board for the M35080 Eeprom:
再配線、ここで読み取られています:
E46 M35080を選択し、E46 Bosch M35080ではありません―これはVINの不正確な表現や他のデータの写真が出てきた理由です。
M35080 EEPROMに元のファイルを保存して、binファイルを編集して別の名前でそれを保存しました。
M35080を消去して、編集された元のファイルをロードします
M35080に新しいファイルを作成しました
確認のため、新しい読み取りを行いた、すべてが順調です。